Introduction
This document describes introduction to various IDM installers currently available and step by step procedure of installing Infor plugins on a machine. This document should be referred when user wants to install Infor plugins for the first time using installer setup.

Note: You will also find installation procedure in installers as well.

Assumptions
Following are the assumptions that were taken into consideration while developing the installer.
1) If you are on Ephesoft 4.0.3.0 then only apply Phase 1 installer, no other installer will work with 4.0.3.0. (Not Recommended)
2) Ephesoft v 4.1.1.0 or higher version is already installed on system.
3) Infor installation is being done for the first time i.e. prior to installation there’s no trace of Infor plugins on user’s system.
4) In case Infor plugins were previously installed then uninstallation procedure is followed before new installation. (Refer Uninstallation Procedure)

Installation Steps:
Fresh Installation Steps:
Follow the below defined steps to install Infor.
1. Stop Ephesoft servers if currently running.
2. Unzip the downloaded artefacts to get the ‘installer’ folder.

Installation on Windows
For installation on windows open “Installer_Windows” folder. Please refer below:

  1. Execute installer.exe present in extracted folder by double clicking. A log file named “installer0.0.log” will be generated in the same directory in which exe is placed.
  2. Open the file. If the line “Installation completed successfully” is present in logs then installation is completed successfully.

Installation on Linux

  1. For installation on Linux open “Installer_Linux” folder. Please refer below:
  2. Open terminal and run “install-infor” file present in above folder.
  3. A log file named “installer0.0.log” will be generated in the same directory in which install-infor file is placed.
  4. Open the file. If the line “Installation completed successfully” is present in logs then installation is completed successfully.

 

Configuration Changes
After completion of installation following configuration changes needs to be done:

  1. Since new plugins have been added, workflows needs to be redeployed. Thus, change the following property to ‘true’. The property is located at ‘<Ephesoft-Installation-Directory>/Application/WEB-INF/classes/META-INF/dcma-workflows/dcma-workflows.properties.’ workflow.deploy=true
  2. Now Restart the Ephesoft servers and Infor plugins should be successfully installed.

 

 

Was this article helpful to you?

Abhishek Jain

Comments are closed.